Alyco

Ficha técnica

1/4 DR. SLIDING TEE HANDLE 100MM

Code
192164
EAN-13
8421504921646
Length (in mm)
100
  • Handle with a movable shaft that allows manoeuvring in limited spaces.
  • It allows action on nuts with more force than with a ratchet, thanks to the possibility of applying force at both ends of the handle.
  • Depending on the position of the nut and space constraints, it can be used as an L-handle, applying very pronounced leverage and considerably increasing the tightening torque
  • The handle and shaft are made of chrome vanadium steel, maximum quality and wear resistance. High tightening torque, allowing high-effort tightening without damaging the wrench. Made of heat-treated steel, giving it more strength and tightening capacity. Great dimensional accuracy, which means the socket and nut are not damaged during tightening and the service life is extended. Tra
  • It can be used with 1/4" square-drive sockets and extension bars. It can also be used with a universal joint and adapters, which increases its functionality

Go to main product

Data sheet

  • Handle with a movable shaft that allows manoeuvring in limited spaces.
  • It allows action on nuts with more force than with a ratchet, thanks to the possibility of applying force at both ends of the handle.
  • Depending on the position of the nut and space constraints, it can be used as an L-handle, applying very pronounced leverage and considerably increasing the tightening torque
  • The handle and shaft are made of chrome vanadium steel, maximum quality and wear resistance. High tightening torque, allowing high-effort tightening without damaging the wrench. Made of heat-treated steel, giving it more strength and tightening capacity. Great dimensional accuracy, which means the socket and nut are not damaged during tightening and the service life is extended. Tra
  • It can be used with 1/4" square-drive sockets and extension bars. It can also be used with a universal joint and adapters, which increases its functionality

    • Overview

    T-handle made up of two parts:
    The sliding handle has two stops to prevent the sliding shaft from coming out of the handle.
    The shaft has a circular hole to slide along the handle and a 1/4" square drive with a retaining ball.
    Handle and shaft made of chrome vanadium steel, for maximum quality and wear resistance. They transmit a high tightening torque, allowing high-effort tightening without damaging the wrench.
    Made of heat-treated steel, giving them greater strength and tightening capacity. High dimensional accuracy, which prevents damage to the nut and extends its service life. Chrome-plated surface treatment, extending service life and preventing oxidation.
    Can be used with 1/4" sockets and bit sockets. It can also be used with extension bars, universal joints, adaptors, etc. to enhance its functions.
    It allows the tightening torque to be increased very considerably, by being able to apply torque from two far-apart points. Torque transmission is also very safe thanks to the very precise fit between the handle and the socket.
    It can be used as a T-handle, placing the shaft in the centre, or as an L-handle, placing it at one end of the handle.
    Complies with DIN 3122 and ISO 3315 standards.
    A very useful accessory for high-effort tightening.

    Technical characteristics

    Finishes

    Material:
    Chrome vanadium steel
    Finish:
    Matte satin chrome-plated

    Certifications

    Certification:
    DIN 3123

    Product dimensions

    Weight (kg) Length (cm) Width (cm) Height (cm)
    0.0450 10

    Documents

    • Certification 1